As a supplier based in China, EPRO MMS 6110 is a dual-channel vibration monitoring module. It specifically monitors the signals transmitted by the eddy current sensors and calculates the actual vibration amplitude of the shaft. Once the value reaches the preset red line, it will immediately send a signal to the control system, closing the gate and stopping the machine operation..
This product is used in all kinds of rotating equipment that must be absolutely error-free. The most typical example is the vibration and displacement monitoring of the turbine shaft in large thermal power plants, which directly affects the safety of the entire power generation unit. There are also radial vibration monitoring for ethylene compressors and synthesis gas compression units in petrochemical plants. Additionally, it can be seen in the key bearings of large blast furnaces' axial flow fans or large water pumps. The EPRO MMS 6110 is the standard vibration protection line for rotating machinery with high speed, high value and catastrophic consequences if mechanical damage occurs.
The EPRO MMS 6110 we offer is meticulously controlled in terms of physical details. The most obvious example is its front LCD display, which has no scratches or yellowish residue from aging, and the backlight display is very uniform. The four aviation plugs inside have shiny gold pins that are as new as they were, without any wear or oxidation due to repeated insertion and removal. The pins on the back are straight and flat, without any crookedness. The metal casing has not been deformed by bumps, and the surface coating is intact. Once you hold it in your hand, you will know that this is a completely flawless spare part that has been well maintained.
Which types of sensors can be directly connected? How is the power supply for the preamplifier provided?
The MMS 6110 is a highly flexible dual-channel module. Have
01/02 and 11/12.
What do the "OK" lights on the front panel of the module indicate respectively?
The green light constantly on: The module has passed self-check, power supply is normal, and there are no short circuits or open circuits in the sensors and their circuits.
The green light flashing: The module is in the power-on initialization self-check stage, or is performing a "sensor automatic calibration" operation triggered by software.
The green light off: Severe fault!
Can the RS232 interface of MMS 6110 be directly connected to the entire factory local area network for remote diagnosis?
Absolutely not! RS232 is point-to-point communication, and the distance cannot exceed 15 meters. If it is necessary to connect to the Ethernet or Modbus RTU (connected to DCS), an EPRO gateway module (such as MMS 6851 or COM 20) must be added in the cabinet.
Address
No. 324, Hubin Street, Nanhu New District, Yueyang City, Hunan Province, China
